Warhead
Posts:
Joined: 12/31/1969
Credibility: pts
|
| Which Parameters Can Be Set Through Console? |
|
|
|
I'd like to configure UT2004's MapVoting to include UTComp settings. I was testing setting UTComp options via console to see if it would work. It seems that some parameters can be set via console, while others cannot. For example, I can set spawn grenade count via ?GrenadesOnSpawn=4, for example, but I can't enable/disable Warmup mode via console (tried both ?Warmup=False and ?bEnableWarmup=False). Is there a list of which parameters can be set through the console (and hence through MapVote) and which cannot? Also, a list of what syntax must be used for each parameter would be helpful - e.g. to set spawn grenades, the command line parameter is GrenadesOnSpawn, whereas the .ini config line is NumGrenadesOnSpawn - DD is DoubleDamage for cmd line whereas .ini line is benableDoubleDamage. Thanks.
|
| 04/14/05 22:54 |
Login to rate this user's post! |
NakedApe
Posts: 0
Joined: 07/01/2004
Credibility: 0 pts
|
| Re: Which Parameters Can Be Set Through Console? |
|
|
|
It's in the readme file, look for "Epic Mapvote".
|
| 04/15/05 00:08 |
Login to rate this user's post! |
Warhead
Posts:
Joined: 12/31/1969
Credibility: pts
|
| Re: Which Parameters Can Be Set Through Console? |
|
|
|
Ah - okay I should have looked there first. Thanks for the reply - too bad those are the only eight parameterst that can be configured via command line - but better those than nothing.
|
| 04/15/05 02:32 |
Login to rate this user's post! |
NakedApe
Posts: 0
Joined: 07/01/2004
Credibility: 0 pts
|
| Re: Which Parameters Can Be Set Through Console? |
|
|
|
Well, if you have any specific requirements, make a feature request. :)
|
| 04/17/05 07:22 |
Login to rate this user's post! |
